All Leashed Products are 4-5 week build time when ordered. But this does change all the time
Billet Map/pressure sensor comes standard now
There is a new option at the bottom for the Boost Leash. You have the option of upgrading to the PRO version of the Boost Leash. The Pro version comes with Pro software and upgraded solenoids. The Pro version allows control in .1 psi increments. The standard controller does 1psi increments. I don't recommend this version unless you run co2 or compressed air type setup.
The Boost Leash Boost Controller by Leash Electronics.
Street/Strip uses of manifold pressure OR co2 pressure for control and it does away with the activation wire and the controller automaticly activates when it senses more that 2psi boost which makes it work VERY well on street cars since its automatic. Simple 3 wire hookup: 12volt, ground, and launch input.
Manual Option
New gear based Boost Leash now available. Simple 4-5 wire hook-up. Ign voltage, ground, scramble ,clutch switch input and auxillary shift input(if motorcycle option is selected below). Controller can run on co2 or manifold pressure. Has a lunch psi setting, number of gears setting, and psi and rate for each gear. The way it works is when the clutch is held for more than 1 second it resets the gears to gear1 and puts the contoller in the launch mode. When the clutch is release the controller goes into gear 1 mode and each time the clutch is pressed it goes to the next gear until the final gear is reached. It only up shifts. It also has an optional shift input that can be connect to air shifter controllers to up shift with a air shifter setup on motorcycles if the motorcycle option is selected below. So to reset down to 1st gear you just hold the clutch for over 1 second and it goes back to gear 1. The controller also has automatic activation so that you dont need a seperate activation switch. When the controller senses more than 2psi boost then it becomes active and runs whatever is programmed.
